MK Diamond MK-5005S - Manual (Page 28)

28
Disconnect the tool before servicing and when changing accessories, such
as blades, bits, cutters, and the like.
(A)
Raise the Cutting Head
(B)
Identify and remove the Retain-
ing Screw and Outer Flange.
Turn counter-clockwise to loosen
(C)
Remove the Diamond Blade
from the Blade Shaft
(D)
Install the new Diamond
Blade onto the Blade Shaft
(E)
Verify the blade is seated on
the Blade Shaft and direction
of rotation is correct
(F)
Install Retaining Screw and
Outer Flange, then tighten.
Rotate Blade Wrench clockwise
to tighten
Diamond Blade change-out
waRNING
MK-5005S TRoUBlESHooTING