MK Diamond MK-5005S - Manual (Page 22)

22
(G)
Turn the saw off when
work is complete
This method may be used when “notching” the masonry piece.
(B)
Turn the motor ON
(A)
Position masonry piece.
Adjust the height of the Cutting
Head as necessary
(E)
Slowly push piece toward
blade to begin the cut
(F)
Continue pushing piece into
blade until cut is complete
(C)
Open the Coolant Flow Con-
trol Valve and adjust flow
(D)
Verify proper Cooling Flow on
both sides of the blade
cutting with the Piece Position Vertically
DO NOT FORCE TOOL, it will do the job better and safer at the rate for which
it was designed.
caUTIoN
MK-5005S oPERaTIoN