Mk-5005s operation – MK Diamond MK-5005S User Manual
Page 19

19
MK-5005S
oPERaTIoN
Step cutting
1. Step Cutting is the preferred cutting method for all cuts.
2. When cutting hard material Step Cutting should always be used.
3. Step Cutting will extend the life of the Diamond Blade.
NoTE:
A Step Cut is performed when a series of small cuts of increasing depth are used to complete a
single cut.
(A)
Adjust the height of the Cutting
Head as necessary, start motor
(B)
Open the Cooling Flow Control
Valve and adjust flow. Verify
proper cooling flow on both
sides of the blade
(C)
Step Cut "Push" Stroke. Lower
Cutting Head 1/4" -1/2"
during Push Stroke
(D)
Step Cut "Pull" Stroke. Lower
Cutting Head an additional 1/4”
to 1/2” and pull Cutting Table
forward
(E)
Repeat Steps C and D until cut
is complete. Turn the saw off
when work is complete
- MK-770 (41 pages)
- MK-770 EXP (46 pages)
- MK-660 (44 pages)
- MK-470 (12 pages)
- MK-377 (36 pages)
- MK-370 (36 pages)
- MK-370 EXP (52 pages)
- MK-170 (36 pages)
- MK-145 (32 pages)
- MK-145 220 Volt (32 pages)
- MK-101 (52 pages)
- MK-101 (56 pages)
- MK-101-24 (52 pages)
- MK-101-24 (56 pages)
- MK-101 Pro / Pro24 (56 pages)
- MK-101 Tracker (45 pages)
- MK-101Pro24 JCS (60 pages)
- MK-101 JCS Rental (51 pages)
- MK-101 Lowes (56 pages)
- MK-101 Lowes (52 pages)
- MK-100 (44 pages)
- MK-100 (52 pages)
- MK-100 Tracker (46 pages)
- MK-100 JCS (49 pages)
- TX-3 (52 pages)
- Saw Tent (2 pages)
- MK-112 (28 pages)
- MK-1070 (22 pages)
- MK-212 (52 pages)
- MK-1590 (36 pages)
- MKDX Profile Milling Machine (40 pages)
- MK-EZ Profile Milling Machine (36 pages)
- MK-1503SS (24 pages)
- MK-1080 (44 pages)
- MK-1080 (1 page)
- MK-1080 (3 pages)
- MK-1280 Gas Saw (48 pages)
- MK-1280 Electric Saw (40 pages)
- MK-1280 Rolling Cart (4 pages)
- MK-1270 (Shindaiwa) (28 pages)
- MK-2000 Electric Saws (52 pages)
- MK-2000 Gas (60 pages)
- MK-5000 Gas Saws (56 pages)
- BX-3 (36 pages)