Metal Sales Seam-Loc 24 Manual - Manual (Page 14)

PSL-14
SEAM-LOC 24 ®
© Metal Sales Manufacturing Corporation/ Subject to change without notice/ Effective Date 9/11
800.406.7387 (Corporate Office) • www.metalsales.us.com
d
esign
/ i
nsTallaTion
C
onsideraTions
(
ConT
)
Panel Endlapping - If panel endlapping is required, endlaps must be staggered. This prevents material build-up and aids in
overall structural performance.
STANDARD PANEL:
 Used when endlapping of panels
is not required
 One panel from eave to peak of roof
 No notching or punching
PEAK PANEL:
 Used when endlapping of panels
is required
 Used as upper panel of endlapping run
 Notching and punching*
 No notching or punching**
EAVE PANEL OR MID PANEL:
 Used when endlapping of panels
is required
 Used as lower or middle panel of
endlapping run
 Notching and punching*
 Notched for panel endlapping**
One panel - Eave to Peak
Two or more panels - Eave to Peak
Standard Panel
Eave Eave
Eave
Peak
Staggered Endlapping
Endlap Purlins
Eave
Panel
Factory Notched Panels - Metal Sales can provide factory notched panel ends to eleminate reliance on field notching for
weathertight seams at panel endlaps.
Panel Installation Sequence
1
2 4 6 8
3 5 7
Panel Endlaps
Peak Panel
Mid Panel
*Longmont, CO only
*Longmont, CO only
*Longmont, CO
**Sellersburg, IN
**Sellersburg, IN
**Sellersburg, IN
3"
3" 3"