Lenze MDSLS Servo spindle motor - Manual (Page 32)

Troubleshooting and fault elimination 8
32 BA 33.0003 EN 1.0
8 Troubleshooting and fault elimination
If faults occur during the operation of the drive system:
ƒ First check the possible causes of malfunction according to the following table.
ƒ Also observe the corresponding chapters in the operating instructions to the other
components of the drive system.
If the fault cannot be remedied using one of the listed measures, please contact the Lenze
Service.
Danger!
ƒ Perform all work at the drive system only in the de-energised state!
ƒ Hot motor surfaces, up to 140 °C. Observe cooling times!
ƒ
Remove the load from the motors or secure loads acting upon the drive!
Show/Hide Bookmarks