Lenze MDSLS Servo spindle motor - Manual (Page 13)

Safety
Definition of notes used
2
13 BA 33.0003 EN 1.0
Waste disposal
Recycle metal and plastic materials. Ensure professional disposal of assembled PCBs.
The product-specific safety and application notes given in these instructions must be
observed!
2.3 Residual hazards
Protection of persons The motor surfaces can become very hot. Danger of burns when touching!
z Install a guard, if necessary.
High-frequency voltages can be capacitively transferred to the motor housing
through the inverter supply.
z
Carefully earth the motor housing.
Danger of unintentional starting or electrical shocks
z Perform connection work only in the de-energised state, only with motor in
standstill.
z Built-in brakes are not fail-safe brakes.
Device protection Built-in thermal detectors are not a full protection for the machine.
z
If necessary, limit the maximum current, perform a function block
interconnection with disconnection after a few seconds of operation with I
> I
N
, particularly if a danger of blocking exists.
z The integrated overload protection does not prevent overload under all
conditions!
Built-in brakes are not fail-safe brakes .
z Speed reduction is possible.
Fuses are not a motor protection.
z
Use current-dependent motor protection switches for average operating
frequency
z Use built-in thermal detectors at high operating frequency.
Excessive torques lead to a break of the motor shaft or demagnetisation
z
Do not exceed the maximum torques according to the catalogue.
Lateral forces from the motor shaft are possible.
z Perfectly align shafts of motor and driving machine to each other.
z
Speeds >3000 min -1 destroy the motor.
Fire protection Fire hazard
z
Prevent contact with combustible substances.
2.4 Definition of notes used
The following signal words and symbols are used in this documentation to indicate
dangers and important information:
Show/Hide Bookmarks