Lenze MDSLS Servo spindle motor - Manual (Page 11)

Safety
General safety and application notes for Lenze controllers
2
11 BA 33.0003 EN 1.0
Application as directed
Drive controllers are components which are designed for the installation into electrical
systems or machinery. They are not to be used as domestic appliances, but only for
industrial purposes according to EN 61000-3-2. The documentation contains information
about the compliance with the limit values to EN 61000-3-2.
When installing drive controllers into machines, commissioning of these controllers (i.e.
the starting of operation as directed) is prohibited until it is proven that the machine
corresponds to the regulations of the EC Directive 98/37/EC (Machinery Directive); EN
60204 must be observed.
Commissioning (i.e. starting of operation as directed) is only allowed when there is
compliance with the EMC Directive (89/336/EEC).
The drive controllers meet the requirements of the Low-Voltage Directive 73/23/EEC. The
harmonised standards of the EN 50178/DIN VDE 0160 series apply to the controllers.
The technical data as well as the connection conditions can be obtained from the
nameplate and the documentation. They must be strictly observed.
Warning: Drive controllers are products with restricted availability according to EN
61800-3. These products can cause interferences in residential premises. If controllers are
used in residential premises, corresponding measures are required.
Transport, storage
The notes on transport, storage and appropriate handling must be observed.
The climatic conditions according to EN 50178 must be observed.
Installation
The controllers must be installed and cooled according to the regulations given in the
corresponding documentation.
Ensure careful handling andavoid mechanical overload. Donot bendany componentsand
do not change the insulation distances during transport and handling. Electronic
components and contacts must not be touched.
Drive controllers contain electrostatically sensitive components which can easily be
damaged by inappropriate handling. Do not damage or destroy any electrical components
since this could mean hazards to your health!
Show/Hide Bookmarks