Mounting steps, Mechanical installation – Lenze E94AZPS User Manual

Page 35

Mechanical installation

Mounting steps

EDK94ZPS113 DE/EN/FR/ES/IT 4.0

3.2

Mounting steps

Proceed as follows for the installation:
1. Prepare M5 threaded holes on the mounting plate according to the

mounting grid.

2. When using footprint filters: Screw installation backplane and footprint

filter together.

–

Use screw and washer assemblies M5 x 20 mm or hexagon socket
screws M5 x 20 mm with washers.

–

Tightening torque: 3.4 Nm (30 lb−in)

3. Screw the installation backplane or footprint filter with installation

backplane onto the mounting plate. Do not yet tighten the screws.

–

Use M5 screw and washer assemblies or M5 hexagon socket screws
with washers.

–

The screw joint in the installation backplane may jut out no more
than 7 mm.

4. Repeat steps 2 and 3 with further installation backplanes which are

mounted side by side.

5. Align all installation backplanes.
6. Screw all installation backplanes/footprint filters onto the mounting

plate.

–

Tightening torque: 3.4 Nm (30 lb−in).