Landoll 9650 Field Cultivator - Manual (Page 47)

ASSEMBLY INSTRUCTIONS
3-7
Inner Wing Frames
1. Attach inner wing frames to center frame using 1-1/4
flange bearings, flat washers, fold pin, and 5/16 x
2-1/2 spring slotted pins (See Figure 3-3.)
Outer Wing Frames
1. Install outer wing frames to inner wing frames using
1-1/4-7 x 7 hex head cap screws, flat washers, and
hex lock nuts in the front (See Figure 3-3.) Note the
direction of bolts as shown in Figure 3-3.
2. The wing fold links (p/n 174447) must be installed
parallel and as close to the wing frame hinge
weldement as possible without gouging into the
square bars welded on the hinge. Washers need to
be either added or removed as needed to obtain the
close and parallel assembly.
3. The 1-1/4-7 x 7 hex head cap screw (p/n 100545)
must be installed loose enough so that the screw can
be turned by hand. This screw must not be
over-tightened so as to cause the hinge assembly to
bind.
Wing Lift Tire Installation
1. All lifts and hubs come already assembled from the
factory.
2. Mount tires on the wheels and install on hubs (See
Figure 3-3.)
3. Recommended tires for inner and outer wings:
11L X 15, 12 ply tires
NOTE
All tire/wheel assemblies are mounted with the valve
stem facing outward.
Front Gauge Wheel Installation
1. Attach front gauge wheel assemblies to the inner and
outer wings using gauge wheel clamp plate, 3/4-10 x
5 hex head cap screws, and hex lock nuts (See
Figure 3-3.) For front gauge wheel placement, see
Figure 2-2.