Landoll XL144/XLC144/XLD144/XLH144/XLO144 X-Fold Pulverizer - Manual (Page 32)

5J801 182rev501 Page 19
26' TO 34' MODELS WHEEL GANG TO WING FRAME ASSEMBLY
Position the two wheel and shaft assemblies in back of the wing frames, placing the shaft with welded ring
clamp next to the hinge side. On Crowfoot models, make sure that the direction of wheel rotation agrees with
the direction of the arrows on the spokes. Place 2J-417 square-bore bearing assemblies onto each end of the
wheel gang stub shafts. Roll the wheel gang between the wing frame end plates to line up the bearings with
mating holes in end plates. Secure with the 1/2" x 1-3/4" capscrews placing the lockwashers and nuts on the
outside of plates.
36' MODELS WHEEL GANG TO WING FRAME ASSEMBLY
Start with the left hand wing. On Crowfoot models make sure that direction of wheel rotation agrees with the
direction of the arrows on the spokes. Position two wheel and shaft assemblies in back of the wing frame with
mating bearings in wheel and shaft assemblies with stub shafts in center bracket. With the plate on the center
bracket with four holes above the gang in a level position, the slant of the center bracket must be the same as
the end plates. Place 2J-417 square bore bearing assemblies onto each end of the wheel gang stub shafts and
rotate center bracket forward.
Roll the wheel gang between the wing frame end plates to line up the bearings with mating holes in end plates.
Secure with the 1/2" x 1-3/4" capscrews placing the lockwashers and nuts on the outside of plates. Rotate
center bracket under the wing frame tube and secure with a four hole plate, four 5/8" x 7" bolts, lockwashers and
nuts. Assemble right hand wing wheel gang in the same manner.