Landoll MCCS2253 18,9 RIGID PULVI-MULCHER - Manual (Page 21)

ASSEMBLY
2-11
Tooth or Tine Installation
After you have all eight brackets assembled, pencil mark
the tooth locations on the Tooth Tubes. Slide the Tooth
Tubes through the Brackets. Both of these Tooth Tubes
must be centered on the machine - an equal length of
tube extending out beyond the outer brackets. Then fix
the tubes in place by assembling straps and U-bolts (2 of
each) to each Tooth Tube. Locate them on the outside of
the inner Tooth Tube Brackets.
See Figure 2-14.
Figure 2-14: Fixing the Tubes in Place
Install S-Tines as shown or C-Teeth (For S-Tine
installation assemble points to Spring Tines before
mounting onto Tooth Tubes.) See Figures 2-15 and 2-16.
Figure 2-15: S-Tine
Figure 2-16: C-Tooth
CLAMP STRAP,
½” U-BOLT, LOCK WASHERS,
AND HEX NUTS
S-TINE
CARRIAGE BOLT,
7/16” X 3-1/2”
CLAMP
HEX NUT
SPRING TOOTH
TOOTH CLAMP
CLAMP STRAP
LOCK
WASHER
HEX NUT
3/8” X 1-1/4” X 4”
½” ½” ,