Landoll MCCS2253 18,9 RIGID PULVI-MULCHER - Manual (Page 14)

2-4 1K965
ASSEMBLY
1. On the Front Frame Tube, Install the bottom 8J118
Spacer using Capscrew 1/2-13 X 5 and Lock Nuts
1/2-13. Note: Do not over tighten - spacer must be able to rotate.
See Figure 2-5.
Figure 2-5: Spacer Installation
1. Install the 8J083 Link. Install the top 8J118 Spacer
using a Capscrew 1/2-13 X 5 and Lock Nuts 1/2-13.
Do not over tighten - spacer must be able to rotate.
See Figure 2-5. 2. Attach the rod end of the Cylinder to the Rockshaft
and the end of the 8J083 link having one hole. Use a
1” X 5 1/2” Pin. The pin should not be locked in place
until later when further assembly is done here. See
Figure 2-6.
3. Install hoses and relief valve at this time. Also refer to
the Hydraulic pages in the repair Parts Manual
1K975 for parts involved in the assembly.
Figure 2-6: Linkage
Spacer
Capscrew
Locknut
Roller Assy. Spacer
Hinge Pin
Roll Pin
5/16 X 2
Roll Pin
1/4 X 2
Pin,
1 X 6 ½
8J083
Linkage
Spacer
Hair Pin
Cotter
Pin,
1 X 5 ½
Klik Pin
1/4 X 1 1/4
1” Flat
Washers
Rockshaft