JUMO 702540 TDA-300 / TDA-3000 - Handheld thermometer Operating Manual - Manual (Page 35)

35
5 Data logger
5.2.4 Checking data
v See “Checking the logged data” on Page 32.
It is possible to check the measured data on the memory screen (Fn1) during
automatic data logging. The total number increases with each new
measurement.
5.3 Searching recorded data
The measured data are recorded in the memory in the order of the individual
measurements. You can use two methods to retrieve the TAG names and
recorded data.
TAG filter You can search data for a specific TAG name.
v Chapter 5.3.1 “Searching data with a specific TAG name (TAG filter)”
LOG jump You can retrieve the data directly from the memory, via the memory number.
v Chapter 5.3.2 “Searching data with a specific LOG No. (LOG jump)”
5.3.1 Searching data with a specific TAG name (TAG filter)
Total number
of recorded
measurements
h In normal display, press the MENU/POWER key
and then the SET key.
The memory screen (Fn1) is displayed.
h Press the UP or DOWN key
( , ) until the
required TAG name is shown on the screen.