JUMO 702540 TDA-300 / TDA-3000 - Handheld thermometer Operating Manual - Manual (Page 27)

27
4 Temperature measurement
To return to normal display, press the ESC key 3 times.
4.1.3 Character entry without selection list
You can also alter the TAG name without the selection list.
Altering
characters
h Use the LEFT or RIGHT key (
, ) to move the cursor to the position of the
character you want to alter.
h Alter the character with the UP or DOWN key (
, ).
Deleting
characters
h Use the LEFT or RIGHT key (
, ) to move the cursor to the position of the
character you want to delete.
h Press the MENU/POWER key twice to confirm deletion.
h Press the SET key to delete the selected character (blinking cursor).
Inserting
characters
h Use the LEFT or RIGHT key (
, ) to move the cursor to the position where
you want to insert a character (in front of the cursor).
h Press the MENU/POWER key three times to confirm insertion.
h Press the SET key to insert a character in front of the cursor.
4.2 Setting limits
When you set the upper and lower limits, these settings will be active at the
next measurement. There are separate limits for each TAG name.
Example You set an upper limit of 90.0°C and a lower limit of 50.0°C for TAG No.2 (TAG
name: PAN02). Proceed as follows:
The cursor blinks on
any character in the display.
v Chapter 4 “Temperature measurement”
h Press the SET key in order to set the upper
limit.
h Press the LEFT key ( ) twice to alter the tens
digit.
blinking