JULABO FPW50-MA Refrigerated and Heating Circulators - Manual (Page 31)

MA
31
• Chloric water can cause pitting corrosion.
• Distilled and deionized water is unsuitable. Their special properties cause
corrosion in the bath, even in stainless steel.
Recommended bath fluids:
Bath fluid Temperature range
soft/decalcified water 5 °C to 80 °C
mixture water/glycol, mixture 1:1
-20°C to 50°C
JULABO bath fluids
JULABO
Description Thermal
G Thermal
HY Thermal
H5
Order Number 10 liters 8 940 124 8 940 104 8 940 106
5 liters 8 940 125 8 940 105 8 940 107
Temperature range °C -30 ... 80 -80 ... 55 -50 ...105
Flash point °C -- 78 124
Fire point °C -- 80 142
Color light yellow clear clear
JULABO
Description Thermal
H10 Thermal
H20S
Order Number 10 liters 8 940 114 8 940 108
5 liters 8 940 115 8 940 109
Temperature range °C -20 ... 180 0 ... 220
Flash point °C 190 230
Fire point °C 216 274
Color clear light brown
See website for list of recommended bath fluids.
ATTENTION:
The maximum permissible viscosity is 50 mm
2
/s
Caution:
Fire or other dangers when using bath fluids that are not recommended:
Use only nonacidic and noncorrosive bath fluids. JULABO assumes no liability for
damage caused by the selection of an unsuitable bath liquid.
Unsuitable bath fluids are fluids which, e.g.,
• are highly viscous
(much higher than recommended at the respective working temperature)
• have a low viscosity and have creep characteristics
• have corrosive characteristics or
• tend to crack.
•
No liability for use of other bath fluids!