Handli ng calls from the 48 0i ct base station – Aastra Telecom 480i CT (Release 1.4) User Manual

Page 29

/ IP Phone User Guide 23

Handli

ng Calls

from

the 48

0i CT Base

Station

You can configure a Park and
Pickup programmable
configuration using the Aastra
Web UI.
Programmable Configuration Using

the Aastra Web UI
On the 480i CT, you configure a
Park and/or Pickup key at
Operation->Softkeys and XML.
You enter a key label, and value for
a specific line on the phone. The
default state of the Park
configuration is "connected". The
default state of the Pickup
configuration is "idle, outgoing".
The 480i CT handsets use the park/
pickup configuration enabled at
Operation->Handset Keys in the
Aastra Web UI. If Park or Pickup
are enabled on more than one line
on the base unit, the 480i CT
handset uses the first
programmable configuration.
For example, if line 1 and line 6 are
configured for park, the 480i CT
handset uses the configuration set
for line 1 to park a call.

Note: Applicable values depend on the

server in your network (Asterisk,
BroadWorks, Sylantro, ININ
PBX. See the table

"Park/Pickup

Call Server Configuration Val-
ues"

page 21.

Configuring Park/Pickup of

Programmable Configuration
Use the following procedure to
configure the Park/Pickup call
feature using the programmable
configuration method.

1. Click on Operation->

Softkeys and XML.

2. Pick a softkey to configure for

Parking a call.

3. In the "Type" field, select Park.
4. In the "Label" field, enter a label

for the Park softkey.

5. In the "Value" field, enter the

approriate value based on the

server in your network.

Note: For values to enter in this field,

see the table

"Park/Pickup Call

Server Configuration Values"

page 21

6. In the "Line" field, select a line

for which to apply the Park con-

figuration.

7. Pick a softkey to configure for

Picking up a call.

8. In the "Label" field, enter a label

for the Pickup softkey.

9. In the "Value" field, enter the