INFICON 2020ppbPRO Portable Photoionization Detector - Manual (Page 15)

ISP-074-576-P1D 9
WARNING
1. All calibration, maintenance and servicing of this device, including battery
charging, must be performed in a safe area away from hazardous locations.
2. Disconnect all power before servicing.
3. Do not open UV Lamp Cap when unit is energized.
4. Only use the AC Adapter in a safe area away from hazardous locations
5. Only use the Serial Port in a safe area away from hazardous locations.
CAUTION
To reduce the risk of fire or injury to persons, read and follow these instructions:
1. There are no operator replaceable parts inside the 2020ppbPRO except the
battery pack, UV lamp and sample inlet filter.
2. For replacement battery pack use only Part No. MX700010 or MX700011.
3. There are no operator serviceable parts inside the 2020ppbPRO.
4. Do not dispose of the battery pack in a fire. The cells may explode. The battery
pack must be disposed of properly. Check with local codes for possible special
disposal instructions.
5. Do not open or mutilate the battery pack. If the 2020ppbPRO is used in a
manner not specified, the protection provided by the 2020ppbPRO may be
impaired.
6. Exercise care in handling battery packs in order not to short the terminals with
conducting materials such as rings, bracelets and keys. The battery or
conductor may overheat and cause burns.
7. Do not defeat proper polarity orientation between the battery pack and battery
charger.
8. Charge the battery pack using the AC adapter provided with or identified for use
with this product only in accordance with the instructions and limitations
specified in this manual. For AC adapter use only Part No. MX350002 (115
Volts AC), MX396013 (220 Volts AC). When using the AC adapter do not block
access to AC outlet in use with adapter. AC adapter is not to be used in a
hazardous area.