INCRA Miter 1000SE User Manual

Page 5

INCRA MITER1000SE OWNER’S MANUAL

Page 5

Flip Fence and Flip Shop Stop - Calibration and Operation

As you look at your new INCRA Flip Shop Stop and
Flip Fence for the first time you will see an interesting
detail. The front face of the fence uses a tongue and
groove arrangement to accept a mating feature on the
flip arms,

Fig. 12. When the flip arm is down with

the two opposing features engaged, it becomes
impossible for the sharp corner of a mitered board
end to wedge between the fence and flip arm. Com-
bined with INCRA’s famous incremental positioning
capabilities, you’ll soon be duplicating cut off lengths
with machine shop precision.

Zeroing the Fence Scales
To zero the main fence scale for 90° work, first set
the protractor to the 0° setting and lock in place.
Clamp the Flip Shop Stop to the fence so that the 0”
mark on the fence scale reads directly under the end
of the gold component of the Flip Shop Stop,

Fig. 13.

Now loosen the (2)

1/4

-20 socket head screws that

secure the fence to the fence mounting bracket and
slide the fence toward the blade until the Flip Arm on
the stop contacts the blade. Re-tighten the fasteners,
Fig. 13A.

For stopped cuts beyond the range of the main fence you’ll need to
calibrate the extender bar scale. Clamp the INCRA Flip Shop Stop to
the 4” fence extender. (Use the scale on the short section of fence as
a reference for clamping the stop to the same position each time you
use it.) Now loosen the

1/4

-20 socket head screw located at the end of

the longer fence and slide the 4” fence and extender bar out. Use
a tape measure to set the distance between the blade and the flip arm
at 16” and re-tighten the fastener,

Fig. 14. Now simply slide the scale

in the extender bar to read 16” at the end of the longer main fence
section,

Fig. 14A.

Fig. 12

Flip Shop Stop

Fig. 13

Zeroing Fence Scale

Fig. 13A

Slide Fence to Blade

Fig. 14A

Align Scale

Fig. 14

Setting Extender Bar Scale

Tongue and groove

Clamp Flip Shop Stop at

0” position

Slide fence until flip

arm contacts blade,

then tighten fasteners

Slide scale to read

16” at end of main fence

Loosen fastener

Clamp

stop to

4” fence

section

Slide extender bar out

until flip arm is 16” from

blade then tighten fastener

Protractor

set at 0°