Epxw expoxy presaturated wipes – HMC Electronics MCC-EPXW MicroCare Stencil Wipes, ExPoxy User Manual
Page 2
5
/
2
VERSION No. 3
EPXW ExPOXY PRESATURATED WIPES
4 FIRST-AID MEASURES
GENERAL INFORMATION
Move the exposed person to fresh air at once. Get medical attention if any discomfort continues.
NOTES TO THE PHYSICIAN
No recommendation given, but first aid may still be required in case of accidental exposure, inhalation or ingestion of this chemical. If in
doubt, GET MEDICAL ATTENTION PROMPTLY!
INHALATION
Move the exposed person to fresh air at once. When breathing is difficult, properly trained personnel may assist affected person by
administering oxygen. Keep the affected person warm and at rest. Get prompt medical attention.
INGESTION
Due to the physical nature of this material it is unlikely that swallowing will occur. DO NOT INDUCE VOMITING! Immediately rinse mouth
and drink plenty of water (200-300 ml). Do not give victim anything to drink if he is unconscious. Consult a physician for specific advice.
SKIN CONTACT
Wash the skin immediately with soap and water. Get medical attention if any discomfort continues.
EYE CONTACT
Make sure to remove any contact lenses from the eyes before rinsing. Promptly wash eyes with plenty of water while lifting the eye lids.
Continue to rinse for at least 15 minutes. Get medical attention if any discomfort continues.
5 FIRE-FIGHTING MEASURES
EXTINGUISHING MEDIA
Use: Powder. Dry chemicals, sand, dolomite etc. Water spray, fog or mist.
SPECIAL FIRE FIGHTING PROCEDURES
Containers close to fire should be removed or cooled with water. Use water to keep fire exposed containers cool and disperse vapors.
UNUSUAL FIRE & EXPLOSION HAZARDS
Combustible Liquid. Rags and the like, moistened with flammable liquids, must be discarded into designated fireproof bucket.
SPECIFIC HAZARDS
Considering the size of the packaging, the risk is regarded as minimal.
PROTECTIVE MEASURES IN FIRE
Self contained breathing apparatus and full protective clothing must be worn in case of fire.
FLAMMABILITY LIMIT -
LOWER(%)
N/A
FLAMMABILITY LIMIT - UPPER(%) N/A
FLASH POINT (°C)
41 C / 106 F TCC (Tag closed cup).
6 ACCIDENTAL RELEASE MEASURES
PERSONAL PRECAUTIONS
Use protective gloves, goggles and suitable protective clothing. Do not smoke, use open fire or other sources of ignition. Provide adequate
ventilation.
ENVIRONMENTAL PRECAUTIONS
Avoid release to the environment. Do not discharge into drains, water courses or onto the ground. Contain spillages with sand, earth or
any suitable adsorbent material.
SPILL CLEAN UP METHODS
Warn everybody of potential hazards and evacuate if necessary. If leakage cannot be stopped, evacuate area. Wear necessary protective
equipment. Extinguish all ignition sources. Avoid sparks, flames, heat and smoking. Ventilate. Dam and absorb spillages with sand, earth
or other non-combustible material. Collect in containers and seal securely.
7 HANDLING AND STORAGE
HANDLING
Do not eat, drink or smoke when using the product. Keep away from heat, sparks and open flame. Avoid spilling, skin and eye contact.
Ventilate well, avoid breathing vapors. Use approved respirator if air contamination is above accepted level.
STORAGE
Store in tightly closed original container in a dry, cool and well-ventilated place. Keep containers tightly closed. Keep away from heat,
sparks and open flame.
8 EXPOSURE CONTROLS/PERSONAL PROTECTION
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440