Ec7m bioact ec7m, aerosol – HMC Electronics MCC-EC7M MicroCare Slow Drying Flux Remover, Citrus Based User Manual
Page 2
Report Date : 01/10/2009
5
/
2
REVISION DATE: 01/10/2009
PRODUCT NO.:MCC-EC7M, MCC-EC7101
EC7M Bioact EC7M, Aerosol
EYE CONTACT
Make sure to remove any contact lenses from the eyes before rinsing. Promptly wash eyes with plenty of water while lifting the eye lids.
Continue to rinse for at least 15 minutes. Get medical attention if any discomfort continues.
5 FIRE-FIGHTING MEASURES
EXTINGUISHING MEDIA
Use: Powder. Dry chemicals, sand, dolomite etc. Water spray, fog or mist.
SPECIAL FIRE FIGHTING PROCEDURES
Containers close to fire should be removed or cooled with water. Use water to keep fire exposed containers cool and disperse vapours.
UNUSUAL FIRE & EXPLOSION HAZARDS
Aerosol cans may explode in a fire. Thermal decomposition or combustion may liberate carbon oxides and other toxic gases or vapours.
SPECIFIC HAZARDS
Vapours are heavier than air and may travel along the floor and in the bottom of containers. Vapours may be ignited by a spark, a hot
surface or an ember. Containers can burst violently when heated, due to excess pressure build-up.
PROTECTIVE MEASURES IN FIRE
Self contained breathing apparatus and full protective clothing must be worn in case of fire.
6 ACCIDENTAL RELEASE MEASURES
PERSONAL PRECAUTIONS
Use protective gloves, goggles and suitable protective clothing. Do not smoke, use naked flames or other sources of ignition. Provide
adequate ventilation.
SPILL CLEAN UP METHODS
Wear necessary protective equipment. Extinguish all ignition sources. Avoid sparks, flames, heat and smoking. Ventilate. Dam and
absorb spillages with sand, earth or other non-combustible material. Collect in containers and seal securely.
7 HANDLING AND STORAGE
USAGE PRECAUTIONS
Keep away from heat, sparks and open flame. Avoid spilling, skin and eye contact. Ventilate well, avoid breathing vapours. Use
approved respirator if air contamination is above accepted level. Keep out of reach of children.
STORAGE PRECAUTIONS
Aerosol cans: Must not be exposed to direct sunlight or temperatures above 50°C.
8 EXPOSURE CONTROLS/PERSONAL PROTECTION
INGREDIENT COMMENTS
WEL = Workplace Exposure Limits
PROTECTIVE EQUIPMENT
ENGINEERING MEASURES
Provide adequate general and local exhaust ventilation.
RESPIRATORY EQUIPMENT
No specific recommendation made, but respiratory protection must be used if the general level exceeds the Recommended Workplace
Exposure Limit.
HAND PROTECTION
For prolonged or repeated skin contact use suitable protective gloves.
EYE PROTECTION
Use eye protection. Wear approved, tight fitting safety glasses where splashing is probable.
OTHER PROTECTION
Wear appropriate clothing to prevent any possibility of liquid contact and repeated or prolonged vapour contact.
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440