HMC Electronics 04007 Hardman Double Bubble Epoxy, Orange/White Packet, High Peel Strength Adhesive User Manual
Page 2
TYPICAL CHEMICAL RESISTANCE PROPERTIES
(Tested at 25 °C unless otherwise indicated)
Total Immersion In:
Immersion
Time, Days
% Weight
Gain (Loss)
Comments
Petroleum Sour Crude
Containing > 5%
Hydrogen Sulfide
1
7
30
0.21
0.37
0.85
Approximately
a 6% loss in
shore hardness
after 30 days.
No swelling or
cracking of the
test specimen
occurs.
Although the recommended mixing ratio is 100A:140B
by weight, the following properties were observed
using a mixing ratio of 100A:100B by weight and curing
for 7 days at 25 °C.
Hardness, Shore D
75
AL/AL Lap Shear Strength, psi
3,315
T–peel Strength, pli
17
STORAGE AND HANDLING
Store DOUBLE/BUBBLE adhesives at room temperature in a
dry environment. Extreme low temperatures may cause
crystallization. Extreme high temperatures may degrade the
properties.
A wide variety of cleaning solutions are available for cured and
uncured epoxies and polyurethanes
SAFETY
These materials are intended for commercial and industrial
use only, and the practices of good housekeeping, safety and
cleanliness should be followed before, during and after use.
Although the system contains low volatility materials, care
should be taken in handling. Use adequate ventilation in the
work area.
These materials may cause dermatitis in susceptible
individuals. Keep off skin and out of eyes. In case of
accidental skin contact, wash thoroughly with soap and water.
In case of eye contact, flush eyes thoroughly with water and
consult a physician immediately.
Refer to Material Safety Data Sheet for additional information.
ADDITIONAL INFORMATION
Visit our web site at:
www.royaladhesives.com
Contact us at:
Royal Adhesives and Sealants, LLC
600 Cortlandt Street
Belleville, NJ 07109-3384
(888)
442-7362
Toll-free
(973)
751-3000
Phone
(973)
751-8407
Fax
NOTE
The statements made herein are based on our research and the research of others, and are
believed to be accurate. No guarantee of their accuracy is made; however, and the products
discussed are sold without warranty, expressed or implied, including warranty of
merchantability and fitness for use of this material, and upon condition that purchasers shall
take their own tests to determine the suitability of such products for their particular purpose.
The user assumes all risk of use or handling, whether or not in accordance with any
statements of the supplier. Supplier’s liability, if any, for any action arising out of the material
being supplied shall be limited to replacement of material. Statements concerning the
possible use of these products are not intended as recommendations to use these products in
infringement of any patent.
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440