HMC Electronics 10-1762 GC Electronics 10-1762 Liquid Tape User Manual
Page 2
USE ADEQUATE VENTILATION
INSTRUCTIONS:
All surfaces must be free of all oils, grease, wax and loose rust. A sandblasted or rough surface improves
adhesion.
Dipping:
Dilute with GC No. 10-6702 up to 25% as needed. Gently mix before each use. Do not introduce air
bubbles. Insert item 1” every 5 seconds. Remove at same rate. Allow 30-40 minutes (dry to touch) dry
time before applying additional coats to desired thickness.
Brushing:
Dilute with GC. No. 10-6702 up to 25% as needed. Gently mix before each use. Apply wet overlapping
coats using a soft natural bristle brush. Allow 10-20 minutes (dry to the touch) dry time before applying
additional coats to desired thickness.
THINNERS:
Toluene, VM &P Naphtha, or Xylene.
RECOMMENDATIONS:
A dry film thickness of 12-15 mils is recommended for best results. Approximate dry mil thickness per
coat, dipping 6-8 mils; brushing 4-5 mils; spraying 2-5 mils. Allow 4 hours dry time per coat before use.
Allow overnight drying whenever possible. When using a dip tank, allow 6” minimum from fluid surface
to tank top to avoid “skinning over “. Avoid excessive air movement, heat or humidity. Always use
proper ventilation and protection.
SHELF LIFE, CLOSED CONTAINERS:
12 months at 77
°F
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440