Gamber-Johnson 7160-0020 - Manual (Page 8)

Place Slide Mtg Brackets over two studs found above the area the back seat
was attached.
Slot the raised area of the floor matting with a knife so Slide Mtg Brackets are
level when attached with (2) 12mm nuts (see FIG 19 & FIG 20).
Position the Slides so the levers release when pushed inward toward each
other (see FIG 21).
Extend the Slides so mounting holes are accessable.
Attach the Slides to the Slide Mtg Brackets and Rear Mtg Brackets with (4)
1/4-20 screws and nuts (see FIG 22).
The screws must be installed from the top (Slide) side and the nuts from the
bottom (floor mat) side, so the Slides move freely.
Drill
9/32" Drill Bit
Ratchet Wrench
7/16" Socket
7/16" Wrench
Knife
8 of 9
Installing Lower Tray Assembly - 7160-0020 (cont'd)
FIG. 19 FIG. 20
FIG. 21 FIG. 22