Gamber-Johnson 7160-0281 - Manual

2011+ Ford F250-F750 Super Duty Truck Base
INSTALLATION INSTRUCTIONS
Product Revision Form #
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
7160-0281 Rev A INST-501
PS-001
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
The purpose of this installation instruction is to illustrate the manufacturer's recommended method of
installation. This vehicle base is a no holes bored solution for 2011 and newer Ford F250-F750 Super Duty
Trucks. It will not fit into previous model year vehicles.
WARNING
• You must read and follow all of the installation instructions. Failure to follow all of the installation
instructions may result in serious bodily injury or death.
• Do not install or use the vehicle base in the area in which the airbag on the vehicle may be deployed if it
is activated. The installer and user of the Ford Super Duty Base are responsible for installing and using
the mounting system outside the area in which an airbag may be deployed if activated. (See Product
Mounting Disclaimer Below)
• Keep these installation instructions with the product and readily available in the vehicle for future
reference of other users of the product.
• Additional copies of the installation instructions can be obtained from Gamber-Johnson.
If you need assistance or have any questions, call Gamber-Johnson at 1-800-456-6868.
• Do not remove warning label from product under any circumstances.
1. Begin by removing the front seatbolts of
the front passenger's seat. Also, loosen the
rear seat bolts on the same seat. It is not
necessary to remove the rear seat bolts, just
back them out enough to be able to tilt the
seat backwards.
2. Tilt the passenger's seat backwards. Slide
the vehicle base underneath the seat frame legs.
Notice the dimples in each of the front legs of
the seat frame. Align the base so that the
dimples on the seat frame legs rest inside the
square cut-outs of the base.
FIG. 1
Ford Super Duty Base
Sheet 1 of 2
© copyright 2010 Gamber-Johnson, LLC
Mounting Base in vehicle: (See figure 1)
Remove Front Seat Bolts
Slide Base under
Seat Frame