Gamber-Johnson 7160-0055 User Manual

Installation instructions, Product revision, Form

Rev.D

INST-326

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

•Do not remove warning label from product under any circumstances.

INSTALLATION INSTRUCTIONS

need assistance or have any questions, call Gamber-Johnson at 1-800-456-6868.

Product

Revision

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

Printing Spec:

PS-001

CHEVROLET IMPALA (2006-+)

of installation of the 2006 and newer Chevy Impala vehicle base.

for installing and using the mounting system ouside the area in which an airbag may be deployed

Form

7160-0055 VEHICLE BASE

if activated. (See Product Mounting Disclaimer Below)
•Keep these installation instructions with the product and readily available in the vehicle for future
reference of other users of the product.
•Additional copies of the installation instructions can be obtainned from Gamber-Johnson. If you

The purpose of this instruction sheet is to illustrate the manufacturer's recommended method

•Do not install or use the vehicle base in the area in which the airbag on the vehicle may be

•You must read and follow all of the installation instructions. Failure to follow all of the installation

deployed if it is acivated. The installer and user of the Chevy Impala Vehicle Base are responsible

instructions may result in serious bodily injury or death.

1. To begin, the front passenger's seat must be
removed from the vehicle floor. Slide the seat
all the way forward to access and remove the
two seat bolts found at the rear of the seat
frame.

2. After removing the seat bolts, slide the seat
all the way back. Tilt the back rest all the way
back. Remove the seat by lifting the back of the
seat first and sliding it towards the back of the
vehicle. Tilt the entire seat back and away from
the mounting area. Remove the two plastic seat
frame covers. They will interfere if left in place.
NOTE: The "hooks" on the front of the seat rails
(see FIG 1). There are two "hooks" for each seat
rail. The space in between the hooks will be
important later in STEP 6.

3. Place the base in the vehicle, with the rectangular cut-outs over the "hook" slots in the floor. Tilt the
seat forward and insert the "hooks" through the rectangular cut-outs in the base and into the mounting
slots on the floor of the vehicle. (see FIG.2)

4. At this point, make sure that there is clearance around the seat "hooks". The base should not be
pinched under the seat frame. With the seat "hooks" properly engaged the base should be able to move
slightly. If it is pinched, it will not move at all and it will be necessary to re-align the seat. Once the base
is aligned properly, replace the seat bolts at the rear of the seat frame.