Gamber-Johnson DS-53 - Manual

DS-53
INSTALLATION INSTRUCTIONS
Product Revision Form
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Vertical Surface Base Rev. B INST-12
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program. Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
1. Place the base in the desired location on the vertical surface. Clamp in place if possible.
Loosen the bolt at the top and tap it to release the upper plate assembly. Test the vertical
adjustment range to be sure it is correct and move the entire base up or down if necessary.
2. Mark the hole locations and drill 17/32" holes, using care not to damage any equipment
behind the panel. Use machine bolts and nuts of the largest size that will fit the holes in the
base. Most bases have holes for 3/8" bolts, but holes for 1/2" bolts are furnished in the taller
bases.
Do not use lag screws or sheet metal screws as these can pull out of the floor.
3. Place bolts through the holes in the base, vertical surface and backup plates, add washers
and nuts, and tighten.
Loosen and tap bolt to
adjust top plate
Back up plates
Place flat against vertical
surface in desired position