Gamber-Johnson 7160-0284 - Manual

Rev.B INST-579
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
rotation of the clevis. The
7160-0284, 7160-0285
TS3 motion attachment allows for 3.5 in. of horizontal travel. The TS5 motion attachment allows for 5.0 in. of
Revision
The Quad-Motion series of products is designed to provide the user with slide, swivel and tilt control of their
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
mounted device. The motion attachment allows for 60 rotation of the arm and 60
horizontal travel.
Product
TS3 & TS5 QUAD-MOTION w/ (NEW CLEVIS)
INSTALLATION INSTRUCTIONS
PS-001 Printing Spec:
MOTION ATTACHMENT -
Form
Product List
Quad-Motion TS3 with clevis attachment: 7160-0284
Quad-Motion TS5 with clevis attachment: 7160-0285
Tools Needed
• 7/16 Wrench or Socket
Assembly
Remove the (3) 1/4 in. nylon jam nuts from the bottom of the device. 1.
Stack the plastic washers and metal washer as shown in Figure 1. 2.
Secure the Quad-Motion device using the (3) 1/4 in. nylon jam nuts removed in step 1. 3.
Tighten the (3) 1/4 in. nylon jam nuts to allow the desired rotational resistance of the arm. 4.
Adjust the torque on the (4) 1/4 in. nylon jam nuts (Figure)2) on the slide to provide the desired sliding 5.
resistance.
7160-0284
METAL WASHER
FIGURE 1
PLASTIC WASHER
PLASTIC WASHER
POLE
1/4 IN NYLON JAM NUT
(4) 1/4 IN.
NYLON JAM NUT
FIGURE 2
7160-0285
© Copyright 2012 Gamber-Johnson, LLC