Gamber-Johnson 7160-0352 - Manual

INSTALLATION INSTRUCTIONS
Product Revision Form
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Rev.A INST-539
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© copyright 2011 Gamber-Johnson, LLC
Printing Spec: PS-001 CF19/Harley Police Tour-Pak Mount
7160-0352
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
These instructions cover installation of 7160-0352 CF19/Harley Police
Tour-Pak Mount.
The Tour-Pak itself should be installed on the motorcycle according to
Harley-Davidson Instructions.
Tools required for installing are a 7/16 Socket and Ratchet or a 7/16 Wrench
and a Phillips Drive Screwdriver
Fig 1 -
Remove the Upper & Lower mounting
plates and Hex standoffs, if installed
inside Tour-Pak.
Leave (5) Rubber Isolator Studs
assembled to bottom of Tour-Pak.
(5) Rubber Isolator Studs
Fig 2 -
Install the 7160-0352 CF19/Harley
Police Tour-Pak Mount over the
Rubber Isolator Studs and secure
with (5) .25-20 Nylok Nuts and
(5) .25 Flat Washers.
The mount will open out
toward the right side of the motorcycle.
(5) .25-20 Nylok Nuts and .25 Flat Washers
1 of 3