Vehicle preparation (cont'd) – Gamber-Johnson 7160-0020 User Manual
Page 4

There are two spring clips located at each end of the seat back at the top, slide a
flathead screwdriver between the deck and the seat back (see
FIG. 5 & FIG 6
).
Depress the top of the clip & pull the seat back out.
FIG. 6
FIG. 5
Large Flathead
Screwdriver
4 of 9
Vehicle Preparation (cont'd)
FIG. 7
Repeat on the opposite side & remove the seat back (
FIG. 7
).
At the front end of the trunk, from inside the rear seat area, cut away the carpet at
the edge of the metal seat back support framework to remove the overlapping
carpet in two places. This exposes the area needed for attaching the two Upper
Tray Slides (see
FIG. 8
).
Drill out the center of the existing slots to 9/32. This hole will be the forward most
mounting position for the Upper Slides. Repeat on the opposite side (see FIG. 9).
Installing Upper Tray Assembly - 7160-0336
FIG. 8
FIG. 9
Drill
9/32" Drill Bit
Knife