Gamber-Johnson 7160-0399 - Manual

FLEX ARM VEHICLE MOUNT
INSTALLATION INSTRUCTIONS
Product Revision Form #
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
7160-0399
A INST-555
•You must read and follow all of these installation instructions. Failure to follow the
installation instructions may result in serious bodily injury or death.
•Do not install or use this assembly in the area in which the airbag on the vehicle may be
deployed. The installer and user of this assembly are responsible for installing and using
this assembly outside the area in which an airbag may be deployed. (See Product
Mounting Disclaimer Below)
•Keep these installation instructions with the product and readily available in the vehicle
for future reference of other users of the product.
•Additional copies of the installation instructions can be obtained from Gamber-Johnson.
If you need assistance or have any questions, call Gamber-Johnson at 1-800-456-6868.
•Do not remove warning label from product under any circumstances.
WARNING
Printing Spec: PS-001
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© copyright 2011 Gamber-Johnson, LLC
1. Loosely install the two u-bolts to the foot as shown (Fig. 1) using the supplied hardware.
2. Remove loom from aluminum rod.
3. Install the foot assembly onto the end of the aluminum rod and loosely tighten u-bolts.
4. Bolt foot to desired mounting point in vehicle (hardware not included). The most convenient
mounting point in most vehicles is the front left passenger seat mounting bolt (bolt foot between seat
rail and floor of vehicle). If your vehicle does not have front seat mounting bolts (most GM cars), you
will need to find another suitable mounting point.
5. The aluminum bar can be bent or cut to length to customize installation. The bar can be bent in a
vice, or over the edge of a board or workbench.
6. Once final shape is attained, reinstall loom, place rod in u-bolts and tighten.
ASSEMBLY
FIG. 1 - U-bolt Assembly
FIG. 2 - Adapter Plate
For left hand rotation
of TabCruzer
install as shown
Notch