ERICO LENTON LOCK Closure Pour Splices - Manual

Mark
Mark
Stop Pin
If stop pin is flush with coupler body:
PUSH PIN IN AND THROUGH CENTER OF COUPLER
If stop pin is not flush with coupler body:
PULL PIN OUT
(Do not push thru)
Step 1: Read all instructions and procedures. Ensure LENTON LOCK is sized properly with project plans.
Refer to product instruction sheet for coupler installation procedure details. Additional copies of instructions
and application information are available at www.erico.com
Step 2 Place coupler on each rebar end until the rebar touches the stop pin.
Mark the rebar to ensure proper coupler/rebar engagement.
Step 3 To allow rebar to pass entirely through the coupler, remove stop pin
by pulling it out or by punching through toward ID of sleeve and discard.
Step 4 Slide coupler onto free rebar.
TECHNICAL SUPPORT:
www.erico.com PDF113_C
INSTRUCTION SHEET
1 of 2
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at www.erico.com and from 1.
your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property damage, serious bodily 4.
injury and death.
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified engineer.
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
LENTON® LOCK Closure Pour Splices
© 2010,2011,2014 ERICO International
Corporation.