ERICO TDSGAPC14 Pipe Mount Grounding Bus - Manual

Clean surface of pipe using a
T313 wire brush. Remove all
paint and oxide layers.
5/16-18 Hex Nut
Apply 12 ft-lbs (Max)
Apply anti-oxide
compound at interface
Loosen to install rods
3/8 Flat Washer
3/8 Belleville Washer
3/8 Hex Nut
Install inner hardware.
Attach clamp to pipe. Tighten hex nuts on U-bolt.
Install threaded rods by loosening hex nut on
connector. Snug hex nut by hand such that the rods
do not fall from the connector. Do not tighten hex nut.
Pipe Size Range: 1.9 to 2.5 inch actual diameter
(1.5 to 2 inch, Schedule 40)
TECHNICAL SUPPORT
www.erico.com IP8260_B 1 OF 2
INSTRUCTION SHEET
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at 1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property 4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
TDSGAPC14
Pipe Mount Grounding Bus
© 2013 ERICO International Corporation.