ERICO ERITECH IBTB Intersystem Bonding Termination - Manual

© 1 OF 2 2009 ERICO International Corporation www.erico.com
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
UL is a registered trademark of Underwriters Laboratories, Inc.
INSTRUCTION SHEET
WARNING:
1. ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets
are available at www.erico.com and from your ERICO customer service representative.
2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds
specified load ratings.
3. All instructions must be completely followed to ensure proper and safe installation and performance.
4. Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction,
property damage, serious bodily injury and death.
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a
qualified engineer.
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
TECHNICAL SUPPORT:
CFS380_F
Electrode
1. Do not disconnect the electrical service grounding conductors while the system is energized.
INTERSYSTEM BONDING TERMINATION
Conductor
CATV
CATV Grounding
NID
Telephone
Conductor
IBTB Telephone Grounding
Conductor
Electrode
Grounding
Note:
2. Follow all local electrical codes as required by Authority Having Jurisdiction.
Intersystem Bonding Termination is also used to bond grounding conductors from television and
Ground Rod
CATV Grounding
Block
Other acceptable bonding
methods not shown.
Example of Intersystem Bonding Termination
Installation- Residential Service
Warning:
radio antennas, satellite dish cable, antenna discharge units and lightning protection systems.
Alternate Location For
Connection of Grounding
Electrode Connector
(Accessible Meter Enclosure).
IBTB