ERICO Plumbing Pre-Fab Bracket - Manual

Tighten hose clamp
around central pipe.
Max Torque: 30 in-lb [3.4Nm]
1
Remove clamps
by pulling up
2
8.00" [203mm]
6.00" [152mm]
4.00" [101mm]
3
Place supply pipes
in appropriate locations
4
Fasten pipes to bracket
with clamps.
Max torque: 15 in-lb [1.7Nm]
Part
Number
Article
Number
Description
Stud Spacing
Central pipe
dia. range
Supply pipe dia.
in [mm] in [mm] CT & IP DN
PFB1624 403100 Telescoping Plumbing Prefab Bracket 15.75-25 [400-635] 1.9-4.5 [48-114] 1/2 - 3/4 15-20
PFBNB 403104 Plumbing Prefab Bracket - 1.9-4.5 [48-114] 1/2 - 3/4 15-20
PFBC 403106 Plumbing Prefab Bracket Clamp - - 1/2 - 3/4 15-20
TECHNICAL SUPPORT:
www.erico.com CFS492_B
INSTRUCTION SHEET
1 OF 2
© 2014 ERICO International Corporation.
Plumbing Pre-Fab Bracket
Adjustable Plastic Plumbing Support
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at 1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property 4.
damage, serious bodily injury and death.
Products that are manufactured using spring steel components shall be used only in a non-corrosive indoor environment. 5.
All pipe supports, hangers, intermediate components and structural attachments must ONLY be used as described herein and are NEVER to be used for any 6.
other purpose.
NOTE: All load ratings are for static conditions and do not account for dynamic loading such as wind, water or seismic loads, unless otherwise noted.
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified
engineer.
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.