ERICO CSBBARJ - Structural Attachment Fitting, Bar Joist Adapter - Manual

ACROSS BAR JOIST ALONG BAR JOIST
DOWN
www.erico.com © 2009 ERICO International Corporation
The customer is responsible for:
UL is a registered trademark of Underwriters Laboratory, Inc.
CFS390_C
a. Conformance to all governing codes.
INSTRUCTION SHEET
All pipe supports, hangers, intermediate components and structural attachments must ONLY be used as described herein and are NEVER to be used for any
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified engineer.
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
NOTE: All load ratings are for static conditions and do not account for dynamic loading such as wind, water or seismic loads, unless otherwise noted.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
TECHNICAL SUPPORT:
1 OF 2
other purpose.
NFPA is a registered trademark of National Fire Protection Association
6.
FM is a registered certification mark of FM Approvals LLC, LTD.
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at 1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property 4.
damage, serious bodily injury and death.
Products that are manufactured using spring steel components shall be used only in a non-corrosive indoor environment. 5.
CSBBARJ
STRUCTURAL ATTACHMENT FITTING
BAR JOIST ADAPTER
FM Approved when used with 1, 1-1/4, 1-1/2, or 2-inch Schedule 40 or GB/T 3091 brace pipe
*(XX) = Finish Specifier
Sway Brace assemblies are intended to be installed in accordance with NFPA-13 and the manufacturer's
installation instructions.
The required type, number, and size of fasteners used for the structure attachment fitting shall be in accordance
with NFPA-13.
FM ® Load Ratings
Across Bar Joist Along Bar Joist Down All Directions
INCH mm lbs. (N) lbs. (N) lbs. (N) lbs. (N)
CSBBARJ(XX) 1/4 to 1/2 6 to 13 3740 (16635) 3000 (13340) 3740 (16635) 4200 (18680)
UL ® Load Ratings
Flange Thickness
*Part Number