Enerpac SQD-Series User Manual

Page 5

4.0 ASSEMBLING THE WRENCH

See

. All parts must be free of dirt and

greased according to Section 6.1. Follow the
steps below:

Slide the reaction arm (6) over the wrench

body (1) in the correct position. See also

and

. Secure the reaction arm with

the locking mechanism (3).

Push drive release (5) into the wrench (1)

and position the square drive (4).

Push the button in the drive release (5)

and push square drive (4) against (5).

Keep pushing (4) while pressing and

turning (5) so both parts click into the
locked position. Check this by pulling the
square drive.

Secure the socket (7) on square drive (4)

using a locking pin (8) and O-ring (9).

IMPORTANT: The Allen-key drive fits in

the same way in the drive release as the
square drive (4). When using the Allen-
key drive the reaction arm for Allen-key
drives (8) must be used.

Connect the Enerpac THC-700 series

3,5:1 safety twin hoses (10) to the swivel
hose connection (2).

WARNING: See

on page 6 for the

correct way to connect the hoses
between wrench and pump.

5.0 CONNECTING THE WRENCH TO THE

PUMP

Enerpac torque wrenches can be powered by
a range of electric or air-driven torque wrench
pumps. For complete operating instructions,
refer to the instruction sheet included with
each Enerpac pump.

IMPORTANT: It is mandatory that

the operator has a full
understanding of all instructions,

safety regulations, cautions and warnings,
before starting to operate any of this high force
tool equipment. To ensure correct pump and
wrench control it is recommended to use an
Enerpac torque wrench pump. When in doubt,
contact Enerpac.

read.eps