Code – Blaupunkt DX-R70 User Manual
Page 109

109
INTRODUCTION
NAVIGATION
RADIO MODE
CD MODE
INDEX
SETUP
CD CHANGER
ENGLISH
DEUTSCH
DEUTSCH
DEUTSCH
✔
The master code input menu opens.
Enter the four-digit master code that is printed on the equipment pass as fol-
lows:
4
use the / buttons on the rocker switch
7
to highlight the first digit of
the master code and
5
press the OK button
8
.
✔
The input cursor jumps one position to the right.
6
Enter the remaining digits of the master code in the same way.
If you entered a wrong digit by mistake,
7
press the ESC button
<
or
7
highlight the symbol and press the OK button
8
.
Once you have finished entering the whole master code,
8
keep the OK button
8
pressed for longer than two seconds or
8
highlight the
symbol and press the OK button
8
.
✔
You will know that the new KeyCard has been accepted when the Travel-
Pilot starts playing the audio source that was active last.
Factory default settings
The following table contains the factory default settings for the TravelPilot.
Setting
Default setting
Display
Day / night
On
Viewing angle
6
Brightness day
7
Brightness night
5
Special effects
0
CODE
0
0
123456789