DIGIWEIGH DWP-98 - Manual (Page 21)

Hints: -
1. For normal comparison, set both HI and LO limits,
2. To check only if result is lower or equal to LO (result
≤ LO), set HI
limit = 0,
3. To check only if result is higher or equal to HI (result
≥ HI), set LO
limit = 0,
4. To check if result is equal to a specified value, set both HI limit and
LO limit = the specified value
6.8.2 Visual and Audio Quantity Check Signals
6.8.2.1 Visual signal: - Quantity check result is displayed by one of the
Check Result Indicators located on Quantity Panel.
6.8.2.2. Audio signal: - depends on setting of internal function F5, audio
signal can be triggered when result is = within range, out of
range or turned off.
6.8.3 To Quit Checkweighing Mode
To quit checkweighing mode, set both HI and LO limits to zero.