DIGIWEIGH DWP-98 User Manual

Page 18

d. To enter new unit piece weight, repeat step b above.

6.5.2 Sampling Process

This method is used where unit piece weight is unknown or the weight of

individual piece is not highly standardized.

a. Refer to 6.2 and 6.4 for zero, selecting preferred weight unit and tare

operation,

b. Place a sample size with known quantity on platter

c. Enter the quantity of the sample through the numeric keypad and

confirm by pressing [# SET].

d. The instrument will automatically determine the unit piece weight and

display it on the Unit Piece Weight Panel

e. Step by step add more load onto the platter (or remove part of the

load from the platter),

The latest Weight, unit piece weight and total quantity would be

displayed on the corresponding panels,

g. To start a new sampling, repeated step a to d above.

6.6 ABOUT AUTO PIECE WEIGHT ENHANCEMENT FUNCTION

In order to obtain the best counting result accuracy, the instrument is

equipped with Auto Unit Piece Weight Enhancement Function. This

function will automatically come into effect when an unit piece weight is

obtained through the sampling method as described in 6.5.2.

6.6.1 How Auto Unit Piece Weight Enhancement Function Works

After a unit piece weight is obtained by methods as described in 6.5.2, then

place more loads onto the platter. The new quantity will be shown on the

Total Count Panel. And at the same time, Auto Unit Piece Weight

Enhancement Function will update the unit piece weight if both below

requirements are fulfilled: -

a. The quantity added to platter is more than 1 piece, and

At this point, sampling process is completed and Auto Piece Weight

Enhancement Function comes into effect.