DIGIWEIGH DWP-98 - Manual (Page 15)

6. INSTRUCTION FOR USE
6.1 POWER ON
Powered on the instrument, instrument displays: -
a. softCAre and revision number and capacity of instrument,
b. calibration count value,
c. parameter set count value,
d. all LCD segments,
Then countdown process starts. After that, the instrument is ready for
operation.
6.2 START WEIGHING
a. If zero weight cannot be obtained when unloaded, press [ZERO]. After
[ZERO] is pressed, Zero Indicator appears. Refer to
SPECIFICATIONS for maximum zero range,
b. AlCAys place an object onto platter gently. Excessive force applied to
platter may cause damages to the weight sensor inside instrument,
c. Weight of the object is displayed on thus unit automatically,
d. It is a good practice to remove all loads from platter after weighing. It
will prolong the life of the weight sensor inside instrument.
6.3 ABOUT WEIGHT UNIT CONVERSION
The instrument supports conversion among weight units. Press [UNIT] to
shift between kg, g and lb.
To enable or disable a particular weight unit, set it ON or OFF respectively
in internal function F9.
The weight unit being employed before power off will be employed when
turned on again.