DIGIWEIGH DWP-98 - Manual (Page 20)


output transaction printout(s)
10
through the RS232 comport. The
instrument returns to normal operation status after 2 seconds,
c. Repeat a for subsequent transactions
11
,
6.7.2 Memory Recall and Clearance
a. Remove all loads from platter,
b. Press [M+] to recall total accumulated weight from memory,
c. After [M+] is pressed, the instrument displays: -
d. The instrument displays: -
 “ACC” on Weight Panel.
 “n” on Unit Piece Weight Panel. n donates the number of
transactions which have been accumulated to memory.

Total Indicator and total accumulated value on Quantity Panel.
e. At this point: -
 Press [ZERO] to quit or,
 Press [CE] to clear memory, then [ZERO] to return to normal
operation status.
6.8 QUANTITY CHECK FUNCTION
12
6.8.1 To Enter High and Lo Quantity Limits
The instrument is equipped with quantity check function. Follow the below
steps to trigger checkweighing mode: -
a. During normal operation, press [CHECK].
b. The instrument displays High Limit and current HI limit value is
displayed on Quantity Panel.
c. Press [TARE] to accept or enter a new HI limit through the numeric
keys and then press [TARE] to confirm,
d. The instrument then displays Lo Limit and current LO limit value is
displayed on Quantity Panel.
e. Press [TARE] to accept or enter a new LO limit through the numeric
keys and then press [TARE] to confirm,
10
The number of copies sent = the number of copy set in internal function F8. Refer
to 5. INITIAL SETUP for more information.
11
Weight reading must return to or below zero to enable another weight
accumulation.
12
Quantity check function will not function when weight reading is less than 20d.