DIGIWEIGH DWP-98 - Manual (Page 17)

f. To cancel tare effect, remove all loads and container from platter and
press [TARE] ,
g. Net Indicator disappears. Tare effect has been removed and weight
reading is gross weight.
6.4.3 Preset Tare
This feature enables the user to manually enter the tare weight. During
normal operation, enter the pre-determined tare weight through numeric
keys then press [TARE]. This pre-determined tare value will be deducted.
To cancel the preset tare effect, remove all loads from platter then press
[TARE].
NOTE: -
1. Refer to SPECIFICATIONS for maximum tare range.
2. Manual tare is possible when preset tare is in effect. Manual tare
will cancel the effect of preset tare.
6.5 QUANTITY COUNTING
Quantity counting starts with determining the unit piece weight either by
keyboard entry or sampling process.
6.5.1 Entering Unit Piece Weight
3 4
This method is used where unit piece weight is known and is highly
standardized.
a. Refer to 6.2 to 6.4 for zero, selecting preferred weight unit and tare
operation,
b. Enter the unit piece weight and press [@WT]. The unit piece weight
is now displayed on the Unit Piece Weight Panel.
c. Place a load on the platter. The weight of the load is displayed on the
Weight Panel and the quantity is displayed on the Quantity Panel.
3
For best counting result, refer to 2.2 for recommended minimum unit piece weight
and weight applied.
4
When the individual unit piece weight is not standardized, it is strongly
recommended that counting procedures as described in 6.6 should be employed.