Despatch MIC1162 Hi-limit - Manual (Page 23)

19
SECTION 4: CONTROL MODE
The Control mode allows viewing of the control status and process variables. Other
modes can be accessed by pressing the SCROLL key until the appropriate mode is
displayed, then pressing the DOWN key.
CONTROL
SETPOINT
CHANGE CONFIGURATION SET-UP
(Ctrl) (SPC) (ConF) (SEt)
If a mode is not enabled it will be skipped over by the routine.
The Setpoint Change mode is used to adjust the limit setpoint(s).
The Configuration mode is used to configure or re-configure the instrument. The input
and output selections are made in the Configuration mode (see Section 6). All possible
parameters are illustrated in Table 6-1. Only those parameters that are applicable to
the hardware options chosen will be displayed.
The Set-Up mode is used to adjust the displays, make alarm settings and retransmit
scaling as needed for proper operation of the instrument. See Section 7 for the Set-up
mode. Only those parameters that are applicable will be displayed.
The Enable mode provides a means of enabling or disabling access to the Program
and Set-Up modes, and enables the Setpoint Change parameter. See Section 8 for
Enable Mode operation.