COATS Speed-Mag Adapter Set User Manual
Page 3
6. On models 1010, 1010A, 2020, 2020A, 3030A and
3040A, install the black upper bead loosener protector
on the upper bead loosener nose to protect the wheel
from possible marring by the bead loosener guide.
Place the upper bead loosener shoe on the tire next to,
but not on, the rim. Be sure the top bead loosener
guide is engaged on the rim (figure 6). Depress the
foot pedal until both bead looseners complete their full
strokes. If the top bead is not completely loosened,
release the foot pedal until the machine completes the
full return cycle, then
depress the foot pedal
again. The ratchet effect of
the upper bead loosener will
deliver a deeper stroke.
Important: Use the sec-
ond stroke only if the upper
bead is not completely loos-
ened by the first stroke.
Figure 6 - Install Protector on Upper Bead Loosener
7.
Check detent control knob for proper setting.
Forward is used for all tire and rim combinations
except 15-inch x 4-inch - 4-1/2-inch, 16-inch x 5-inch - 5-
1/2-inch, and 17.5-inch x 5-1/2-inch - 6-1/2-inch.
Relocate detent knob by pushing it down and moving
forward or backward to the proper setting.
Figure 7 - Position Detent Knob
8. Install the combination tool end protectors.
Figure 8 - Install Tool Protectors
9. Demount the tire in the usual manner. Make cer-
tain the plastic protector is positioned to completely
cover the end of the tool. Always apply plenty of rub-
ber lubricant to tire beads.
Figure 9 - Demount the Tire
10. Mount the tire in the usual manner. Make cer-
tain the plastic protector is positioned to completely
cover the end of the tool. Always apply plenty of rub-
ber lubricant to tire beads.
Figure 10 - Mount the Tire
Styled Steel Wheels
1. Place wheel over center post onto table top.
Guide the positioning pin into a lug hole.
2. Slide styled steel wheel adapter tube over post
and into wheel center hole (flange up).
Figure 11 - Install Styled Steel Wheel Adpater Flange Up
3. Invert the hold down cone and tighten the assem-
bly to the table top.
Figure 12 - Install Hold Down Cone
4. Mount and demount tire as usual.