COATS Kit 85607770 Tire Inflation Cage - Manual (Page 9)

COATS • 9
Inflating Tire Using Nitrogen
1. Press or button on autoflate to
set desired pressure. Connect the inflation hose with
the clip-on chuck to tire valve stem and inflation will
begin automatically.
Note: Press the button if inflation does not
automatically start.
2. The unit inflates tire to preset pressure. When it
reaches the preset pressure it will purge to the percent-
age of the preset purge parameter (BL2).
It then inflates the tire to the preset pressure.
Note: This process repeats according to the RPT
parameter number that is programmed.
3. DO NOT STAND IN TRAJECTORY ZONE DUR-
ING INFLATION. When inflation is complete, the auto-
flate unit will beep and the pressure will flash on the
display.
Topping Off A Tire That Already Has Nitrogen
1. Press or button on autoflate to
set desired pressure. Connect the inflation hose with
the clip-on chuck to tire valve stem and inflation will
begin automatically.
It then inflates the tire to the preset pressure.
2.
DO NOT STAND IN TRAJECTORY ZONE DUR-
ING INFLATION. When inflation is complete, the auto-
flate unit will beep and the pressure will flash on the
display.
Replacing Air In Tire With Nitrogen
1. Press or button on autoflate to
set desired pressure.
2. Deflate the tire by removing; then replacing the
valve core. Next, connect the inflation hose with the
clip-on chuck to tire valve stem.
3. Press the button to start the N2 conver-
sion.
It then inflates the tire to the set pressure. When it
reaches the set pressure it will purge to the percent-
age of the preset purge parameter (BL2). It will then
re-inflate the tire to the preset pressure.
Note: The unit will repeat this operation according to
the set RPT parameter.
IMPORTANT: When the set pressure is greater than
40 PSI the unit will inflate to 40 PSI; and then prompt
you for confirmation to proceed. Check tire and press
any button to complete tire inflation procedure greater
than 40 PSI.
Once the process is completed, the unit will stop,
beep and flash “END”, which will indicate that the tire
is ready.