beautypg.com

COATS Kit 85000805, Carrier User Manual

Caution

background image

Parts List

Part No. Description

8185679 Clamp Carrier

8182279 1/2-13 UNC, Hex Link Bolt

903174 5100-75 Ext. Retaining Ring

8185035 0.512 ID x 0.787 OD x 0.079 Washer

8185018 5100-46 Ext. Retaining Ring

85000803 Packet Loctite®

Loctite® is a trademark of Henkel Corporation

Tools Required: Screwdriver, 15mm Combination

Wrench, Snap Ring Pliers, 3/4-inch Socket, 1/2-inch
Drive Ratchet, Dead Blow Hammer, 9/16-inch
Combination Wrench, Allen Wrench, Torque Wrench

Installation Instructions

Always DISCONNECT THE ELECTRICAL
POWER before servicing equipment. This
prevents electrical shock or accidental
movement of the systems operated by the
electrical power.

Always DISCONNECT AIR SUPPLY before
servicing equipment. This prevents acciden-
tal movement of systems operated by com-
pressed air which may result in personal
injury. BLEED THE AIR SYSTEM by actuating
all the valves.

1. Before beginning any work, clear the area, position

clamps in outer position, and rotate table top for easy
access to the carriers. Disconnect all power sources,
both air and electricity inputs. Allow any stored air in the
reservoir to escape by depressing the inflate pedal.

2. Verify the stored air pressure is zero by observing

the air pressure gauge on top of the tower.

3. Disconnect

air line at carri-
er’s elbow fit-
ting. Repeat on
opposite side.

4. Loosen and then remove the four table top hose

holders. If necessary, remove air hose and use screw-
driver to provide leverage when loosening hose holder.

5. Remove outer retaining rings and washers from

both cylinder mounting shafts. Slide the cylinders off.

6. Next, remove the inner retaining ring that holds the

cylinder mounting shaft on the carrier and slide the
cylinder mounting shaft out.

7. Loosen and remove the table top link bolt to

remove the old carrier assembly.

CAUTION

CAUTION

85000804 00 07/07 1 of 2

© COPYRIGHT 2007 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.

Carrier Kit 85000805

For use with COATS Model

APX Series Tire Changers

Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565 (800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com

Inner Retaining Ring

Outer Retaining

Ring & Washer

Outer

Retaining

Ring &

Washer

Table Top

Link Bolt

Cylinder Mounting Shaft

Air Line At

Elbow Fitting

Hose

Holder