COATS Kit 85000443, PAX Accessory - Manual (Page 3)

COATS PAX Kit • 3
• Place large diameter side of
tire/support over small diameter of
wheel.
• Position roller and lubricate bead
area of tire.
• Rotate tire; push support system
into location.
Note: Small roller may contact rim.
Mounting Tire With Support
• Lubricate lower bead and make
sure bead is in small drop center.
• Flip lower bead to outside of rim.
• Place small roller against tire and
rim; lubricate tire bead, place
bead lock clip; rotate tire slow.
• Position roller over tire and rim
and lubricate bead area of tire.
• Use lock clip; slide bead in place.
• Add about 10 pounds of air pres-
sure to tire with core in location.
• Using roller, apply a little force to
assure bead is in correct location.
• Repeat on lower bead.
Bead Position Prior To Inflation
• Raise lift and wedge tire.
• Lubricate tire bead edges.
• Use hands to pull tire sidewall up. • Inspect to assure clips on support
match groove on wheel once tire is
installed on rim. • Use lift tool to wedge support
completely into the tire.
Install Support Inside Tire