COATS AirNut - Manual (Page 5)

COATS AirNut • 1
Before You Begin
Receiving
The shipment should be thoroughly inspected as
soon as it is received. The signed bill of lading is
acknowledgement by the carrier of receipt in good
condition of shipment covered by our invoice. If any of
the goods called for on this bill of lading are shorted or
damaged, do not accept them until the carrier makes
a notation on the freight bill of the shorted or dam-
aged goods. Do this for your own protection.
NOTIFY THE CARRIER AT ONCE if any hidden loss or
damage is discovered after receipt and request the
carrier to make an inspection. If the carrier will not do
so, prepare a signed statement to the effect that you
have notified the carrier (on a specific date) and that
the carrier has failed to comply with your request.
IT IS DIFFICULT TO COLLECT FOR LOSS OR DAM-
AGE AFTER YOU HAVE GIVEN THE CARRIER A
CLEAR RECEIPT.
File your claim with the carrier promptly. Support
your claim with copies of the bill of lading, freight bill,
invoice, and photographs, if available. Although
COATS’ responsibility ceases upon delivery of the
shipment to the carrier, we will gladly assist in tracing
lost shipments. Our willingness to assist in every pos-
sible manner does not make COATS responsible for
collection of claims or replacement of lost or damaged
materials. Shipping damage claims will not be handled
under warranty.
Specifications
Minimum Air Pressure Required . . . . . . . .120 PSI
Maximum Air Pressure Required . . . . . . . .200 PSI
Clamping Force . . . . . . . . . . . . . . . .*Over 850 lbs.
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . .3.5 lbs.
Capacity . . . . . . . . . . . . . . . . . . . . .Extends 1.250"
*At Minimum Pressure
Air Requirements
Connect to an air supply that delivers between 120
PSI to 200 PSI.
For convenience to the user and longevity of the
AirNut…
• Run a separate air line to the balancer.
• Mount the regulator assembly and air gun to the
wheel balancer’s hood as outlined in the instruc-
tions on page 2.
• Add a water trap and oiler to the air line that will
feed the AirNut.
Standard Accessories
The following are standard accessories included with
the AirNut.
1. Pressure Cup (Part #112579)
2. Rubber Cushion (Part #112580)
3. No Mar Ring (Part #112581)
Figure 1 - Standard Accessories
Optional Accessories
There are two optional accessories available for the
AirNut.
1. Alu-Cup pressure cup (Part #112382) fits 40mm
shaft or (Part #111518) fits 1 1/8 shaft.
Figure 2 - Alu-Cup pressure cup
2. Inline water trap and oiler (Part #110495)
Figure 3 - Inline water trap and oiler
AirNut
#112581 #112580 #112579
Drain
Petcock
Air In
Oil Flow
Adjust Oil Fill
Separator Lubricator Air Out