Safety, Caution warning danger, Warning – COATS AirNut User Manual
Page 3
COATS AirNut • iii
Owner’s Responsibility
To maintain machine and user safety, the responsibility
of the owner is to read and follow these instructions:
•
Follow all installation instructions and make sure
installation conforms to all applicable Local, State,
and Federal Codes, Rules, and Regulations; such as
State and Federal OSHA Regulations and Electrical
Codes.
•
Carefully check the unit for correct initial function.
•
Read and follow the safety instructions. Keep them
readily available for machine operators.
•
Make certain all operators are properly trained,
know how to safely and correctly operate the unit,
and are properly supervised.
•
Allow unit operation only with all parts in place and
operating safely.
•
Carefully inspect the unit on a regular basis and per-
form all maintenance as required.
•
Service and maintain the unit only with authorized
or approved replacement parts.
•
Keep all instructions permanently with the unit and
all decals/labels/notices on the unit clean and visible.
Definitions of Hazard
Levels
Identify the hazard levels used in this manual with
the following definitions and signal words:
DANGER
Watch for this symbol:
It Means: Immediate hazards, which will result in
severe personal injury or death.
WARNING
Watch for this symbol:
It Means: Hazards or unsafe practices, which could
result in severe personal injury or death.
CAUTION
Watch for this symbol:
It Means: Hazards or unsafe practices, which may
result in minor personal injury or product or property
damage.
Watch for this symbol! It means BE ALERT! Your
safety, or the safety of others, is involved!
CAUTION
WARNING
DANGER
Safety
Failure to follow danger, warning, and caution
instructions may lead to serious personal
injury or death to operator or bystander or
damage to property. Do not operate this
machine until you read and understand all the
dangers, warnings and cautions in this man-
ual. For additional copies of either, or further
information, contact:
Hennessy Industries, Inc.
1601 J.P. Hennessy Drive
LaVergne, TN 37086-3565
(615) 641-7533 or (800) 688-6359
www.ammcoats.com
WARNING