CHAMPION DH5000 VHR Manual - Manual (Page 30)

22
1. Turn the main power on at the main circuit breaker.
2. Make sure the spray arms and the scrap screens are in place.
3. Turn the water supply on.
4. Close the dishwasher hood.
5. Push the Cycle Selector Switch DOWN to the EXTENDED position.
6. Push the dishwasher Power Switch to the ON position. The power switch will illuminate
and the machine will fill with water.
Operation
Extended Wash Cycle Operation
POWER WASH
ON
PRESSURE
STANDARD
EXTENDED
RINSE
180°F
CYCLE
OFF/DRAIN
WASH
150°F
1 5 0 1 7 0
Follow the instructions below to operate the dishwasher in a Extended Wash Cycle. A Rinse
Sentry feature holds the dishwasher in a wash cycle if the booster heater temperature is below
180ºF/82ºC.
POWER WASH
ON
CYCLE
PRESSURE
STANDARD
OFF/DRAIN EXTENDED
WASH
150°F
RINSE
180°F
1 5 0 1 7 0
! VERY IMPORTANT !
THE EXTENDED CYCLE MAY BE SELECTED BEFORE OR AFTER THE POWER SWITCH IS PRESSED; BUT,
THE CYCLE SELECTOR SWITCH WILL NOT CHANGE THE CYCLE FROM STANDARD TO EXTENDED OR
VICE VERSA WHILE THE DISHWASHER IS ALREADY IN CYCLE.